Regulations For Usa And Canada - GE Peristaltic Pump P-1 Operating Instructions Manual

1 Introduction
1.3 Regulatory information

1.3.3 Regulations for USA and Canada

1.3.3 Regulations for USA and Canada
Introduction
This section describes the regulations that apply to the Peristaltic Pump P-1 instrument
in the USA and Canada.
NRTL certification
This symbol indicates that the product has been certified by Intertek, which is a US Oc-
cupational Safety and Health Administration Nationally Recognized Testing Laboratory
(NRTL).
FCC compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
•
•
10
The user is cautioned that any changes or modifications not expressly approved
by GE could void the user's authority to operate the equipment.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Peristaltic Pump P-1 Operating Instructions 28962201 AF