Table of Contents
Advertisement
Indoor Unit Installation
Step 2-5 Optional: Extending the power
cable
1
Prepare the following tools.
Tools
Crimping pliers
Connection sleeve
20xØ6.5 (HxOD)
(mm)
Insulation tape
Contraction tube
70xØ8.0 (LxOD)
(mm)
2
As shown in the figure, peel off the shields from the
rubber and wire of the power cable.
•
Peel off 20 mm of cable shields from the pre-
installed tube.
CAUTION
•
For information about the power cable specifications
for indoor and outdoor units, refer to the installation
manual.
•
After peeling off cable wires from the pre-installed
tube, insert a contraction tube.
•
If cable wires are connected without using connecting
sleeves, their contact area becomes reduced, or
corrosion develops on the outer surfaces of the wires
(copper wires) over a long time. This may cause an
increase of resistance (reduction of passing current)
and consequently may result in a fire.
Power cable
180
120
60
20
20
12
English
DB68-08947A-00_IM_CAC QMD_EU_EN_.indd 12
Spec
Shape
MH-14
Width 19 mm
(Unit: mm)
20
20
20
60
120
180
Pre-installed
tube for the
20
power cable
3
Insert both sides of core wire of the power cable into the
connection sleeve.
•
Method 1: Push the core wire into the sleeve from
both sides.
•
Method 2: Twist the wire cores together and push it
into the sleeve.
Method 1
Connection sleeve
4
Using a crimping tool, compress the two points and flip
it over and compress another two points in the same
location.
•
The compression dimension should be 8.0.
•
After compressing it, pull both sides of the wire to
make sure it is firmly pressed.
Method 1
Compress it 4 times
5 mm
5
Wrap it with the insulation tape twice or more and
position your contraction tube in the middle of the
insulation tape.
Method 1
Insulation tape
40 mm
Method 2
Connection sleeve
Compression
dimension
Method 2
Compress it 4 times
5 mm
Method 2
Insulation tape
35 mm
2020-02-10 오전 11:14:29
Hide quick links:
Advertisement
Table of Contents
