Before You Begin Using Your Wdt3200; Installing The Battery Pack - Wasp WDT 3200 Product Reference Manual

Wasp bar code scanner product reference guide

Hide thumbs Also See for WDT 3200:

Table of Contents

Before You Begin Using Your WDT3200

Before using the WDT3200, please ensure the battery is fully charged.

There are three ways to charge your WDT3200:

Docking Station

RS232/Charging cable or USB/Charging cable

Rechargeable Lithium-Ion battery pack

CAUTION:

not fully charged. This data loss can occur if the main battery has been drained

and the unit is not connected to the AC adaptor. For this reason, it is crucial that

before you charge the main battery, you make sure the backup battery switch is

set to ON. For further information on turning on the backup battery switch,

please see the next page.

Wasp Barcode Technologies recommends that you charge the battery at least 12

hours before using for the first time. After the initial charge, a fully drained

battery can be recharged in about 4 hours. While charging the main battery the

backup battery will also be charged if the backup battery switch is set to "ON".

1. Remove the battery door.

2. Move the backup battery switch to the ON position.

Off

There is a high risk of data loss if the WDT3200's backup battery is

WDT 3200 Product Reference Guide

Table of Contents