Marantz SR5015 Owner's Manual page 208

Contents Connections
3
Connect the Sound calibration microphone to the
SETUP MIC jack of this unit.
When the Sound calibration microphone is
connected, the following screen is displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone and microphone stand.
Set the following items
if necessary.
Amp Assign
Channel Select
Dolby Speaker Setup
Start
Front panel Display
Playback Settings
4
Select "Start", then press ENTER.
Audyssey
5
Follow the instructions on the screen display and press
"Next" to proceed further.
208
Rear panel
Tips
® Setup can also make the following settings.
Amp Assign
0
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. ("Amp Assign" (v p. 215))
Channel Select
0
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers.
Dolby Speaker Setup
0
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when "Assign Mode" is set to "Front Dolby" or
"Surround Dolby" in the "Amp Assign" settings. (v p. 215)
Remote Index
Appendix