Connecting The Trailer To A Bicycle - QERIDOO Speedkid1 2020 User Manual

Utilisation

Connecting the trailer to a bicycle

Danger!
Do not connect the
fulfilled:
The trailer is fully loaded.
»
The children wear a bicycle helmet or use a head rest and are properly belted.
»
The buggy wheel has been removed.
»
The tow bar load has been checked and is within the permissible
»
range (0 – 8 kg).
Remove the retaining cotter pin from the tow bar
»
coupler pocket.
Push the tow bar onto the coupler of the bicycle so
»
that the cotter pin holes in the coupler and tow bar
couplet pocket are one above the other.
Insert the cotter pin into the hole and lock the cotter
»
pin fastening.
Check that the connection between the coupler and
»
the tow bar is secure.
Guide the tow bar's retaining strap through the
»
braces of the rear wheel so that the trailer is securely
connected to the bicycle frame.
Fix the safety strap using the clamping buckle on the tow bar head. Make sure that it cannot
»
flutter into the spokes of the rear wheel while riding. If necessary, wrap the safety strap
several times around the bicycle frame and fix the end of the strap with the rubber ring on the
shaft of the tow bar.
Danger!
Always make sure that the safety strap is in place before using the stroller in trailer
mode. In addition, make sure that the safety strap cannot get into moving parts of
the pushchair.
Danger!
Always secure the tow bar to the bicycle frame with the retaining strap. This
ensures that the trailer will remain connected even if the tow bar becomes
detached from the coupler.
Irrespective, the coupler must always be properly mounted and the connection
to the tow bar must be secured with the locked cotter pin. Otherwise the tow
bar can be come detached and can be pushed into the rear wheel's spokes
during braking.
Speedkid 2020
Speedkid to a bicycle until the following conditions have been
Subject to change without notice. – 07|2020 – 25