Assembly; Unpack Contents; Unfolding The Cabin - QERIDOO Speedkid1 2020 User Manual

Assembly

Below you can read all the information that you will need to assemble your
Make sure that you have sufficient space to assemble it. Also pay attention to the door width
at the place of installation: The
Speedkid2 is 87 cm wide.
Perform each of the instructions step by step.
»
If necessary, follow the QR code to call up a video about assembly and
»
operation on the Internet.
You can find our video tutorials on our YouTube channel www.youtube.
»
com/user/Qeridoo
Danger!
Never perform assembly work if there are children in the cabin. Keep children
away from the vehicle during assembly.
When handling moving components, make sure that your hands or fingers do not
get trapped. Before first use, check all screw and plug connections for tightness.

Unpack contents

Remove the packaging material and all protective caps, and dispose of them
»
in accordance with the environmental guidelines that apply in your region.
Cut the zip ties at the rear of the cabin
»
Read the chapter „Assembly" on page 12 before you assemble parts.
»

Unfolding the cabin

Place the collapsed cabin in the assembly area.
»
Stand in front of the cabin and hold the tube of the
»
rear roof rack with one hand.
Open the cabin by pushing the tube upwards.
»
Hold each of the side tubes of the folding system
»
by the lower part of the hinge.
Press both hinges down until they engage audibly.
»
12 – 07|2020 – Subject to change without notice.
Speedkid1 is 77 cm wide with the wheel guards fitted and the
Speedkid properly.
Speedkid 2020