Vulcan-Hart Fryers Control Manual

Vulcan
SoLid STaTE conTroLS guidE
Programming in 7 Easy Steps
1
STEP
Fill fry tank with oil and
then turn power on
2-7
STEP
Programming modES
To make changes
to your program:
1. If display is
locked it must be
unlocked using the
unlock code.
To
unLocK
this control you
must quickly press the
LEFT LEFT righT righT
buttons while the
word 'LocKEd' is
displayed
unLocK codE
2. After unlocking
go to steps
2 –
7
To SToP a TimEr oncE ThE counTdown SEquEncE haS STarTEd:
Press and hold the timer
button until timer is reset and
flashing light goes OFF.
F-32912 (January 2007)
Fryers
Display will scroll through VULCAN
2 3
Press program button
to enter the program mode:
LEFT TIMER displays
Press to increase time.
LEFT
Press to decrease time.
RIGHT
Press to go to Step 3.
6
7
UNLOCK displays
Press to LOCK.
LEFT
Press to UNLOCK.
RIGHT
Press to go to Step 7.
Note: VULCAN recommends
keeping the controls LOCKED after
programming to prevent altering
LEFT TIMER
BUTTON
www.VulcanHart.com • Fryer Technical Support: 1-800-814-2028
(for revisions V3.00 or higher)
FRYERS
➤
4
RIGHT TIMER displays
Press to increase time.
LEFT
Press to decrease time.
RIGHT
Press to go to Step 4.
Press button and HOLD
FOR 3-5 seconds to save
and exit program mode.
Note: Programming modes can
be initiated while the fryer is
ON by pressing the button.
If 'LOCKED' appears refer to
'UNLOCK' code.
LIGHTS
LEFT RIGHT
Rev. No. MELT CYCLE LIQUID
➤ ➤
5
MELT CYCLE
TEMPERATURE SETTING
Press
displays
"S"
Press to increase temp.
LEFT Press
NO
Press to decrease temp.
RIGHT
Press
"L"
Press to go to Step 5.
Press
oPTionaL diSPLay modES
After the program mode is completed, one
of the following screens will be displayed.
TEMPERATURE
SETTING RESULTS
Results of programming for Results of programming
oil temperature is at set
temperature
Display shows
ACTUAL TEMPERATURE
Results of programming
Results of programming
RIGHT TIMER
BUTTON
temperature is below 135 º F
displays
to change to
LEFT
Solid.
to change to
LEFT
MELT.
to change to
LEFT
Liquid.
to go to Step 6.
MELT CYCLE RESULTS
MELT L
MELT L
Display says
MELT S
MELT S
Display says
NO MELT
Display says HEATING if oil