Ryobi RPP254JO Original Instructions Manual page 15

GETTING STARTED
2b
2
1
Align the button with the guide recess on the power head
shaft coupler and slide the two shafts together. Rotate
the pruner attachment shaft until the button locks into the
positioning hole. Tighten the knob securely.
7
50 : 1 / 2%
(50 : 1)
Use synthetic 2-stroke lubricant only. Do not use automotive
lubricant or 2-stroke outboard lubricant. Mix 2% synthetic
2-stroke lubricant into the petrol. This is a 50:1 ratio.
3
3
2
1
Loosen and remove the oil cap. Add bar and chain lubricant
in the bar lube reservoir for automatic bar and chain
lubrication. Place cap and tighten securely.
NOTE: Use chain and bar oil only. Other oils will not stick
to the chain properly and will result in damage to the chain
and bar.
8
3
1
2
4
Loosen the fuel cap. Remove the fuel cap. Carefully pour
fuel mixture into the tank. Avoid spillage. Immediately
replace fuel cap and hand tighten.
GETTING STARTED
4
2
1
3
4
Attach the J-handle. Insert the end of the J-handle between
the clamps so that holes align and handle will be located to
the operator's left side. Push the bolt through the clamp and
handle. Install flat washer and lock nut to hold the assembly
in place. Adjust the position of the handle. Tighten the nut
securely.
Attach the shoulder strap hanger.
13