Starting A Cold Engine - Ryobi RPP254JO Original Instructions Manual

OPERATION

STARTING A COLD ENGINE

1. Lay the product on the ground, press the
primer bulb 10 times, and then set the lever
to choke position.
NOTE: The fuel should be visible in the
primer bulb after the 7th press.
2. Hold down the throttle lock, squeeze the
throttle trigger (through step 4), and then pull
the starter grip until the engine starts. Do not
pull the starter grip more than 4 times.
3. Set the lever to choke position. Pull the
starter grip until the engine starts. Do not pull
the starter grip more than 6 times.
NOTE: If the engine does not start, repeat
the procedure again from setting the choke
lever to choke position.
4. Allow the engine to run for 10 seconds, then
set the choke lever to
1
2
3
2
position.
3
4
1
x10
1
1
2
1
2
4x
3
6x
4
2
19