Table of Contents
Advertisement
Before starting to increase the capacity of the HDD by installing the BKMA-U55, confirm that the MAV-
555 and the related optional units are version 2.00 or higher. For upgrading the system to the newest
version, upgrade it by referring to the CD that is supplied with the BKMA-U55.
m
. When capacity of the HDD is increased by installing the BKMA-U55, the "ALL ERASE" menu needs
to be executed after replacement of the hard disk. Because the pre-recorded materials will be all erased,
copy of all the necessary materials to VTR and others for backup purpose.
. Be sure to implement the "ALL ERASE" menu from the application software when it is connected to
an application.
. All of the work procedures to increase the capacity of the HDD by installing the BKMA-U55 must be
executed while the system power is kept turned off.
2-1. Replacement Procedure
To replace the HDD, perform the following steps starting from the top in this order. For details, refer to
each item.
Confirming versions of MAV-555 and
BKMA-505/510/520/530/560
Upgrading versions of MAV-555 and
BKMA-505/510/520/530/560
(Only when it is necessary)
Replacing HDD of MAV-555
Setting Switch of PU-109 Board
Erasing All Materials after Installation of HDD
(Logical format)
Confirming Operation
2-2. Confirming Versions of MAV-555 and BKMA-505/510/520/530/560
Required tools
. PC (System requirement: Any of Windows 95/98/2000/NT4.0)
. Ethernet card
. Ethernet cross cable
. Version check software: GCD Loader V0.21 (This is stored in the supplied CD.)
Connection
Connect the Ethernet terminal of the rear panel to a personal computer using an Ethernet cross cable.
BKMA-U55
Section 2
Replacement of the Hard Disk Drive
Refer to Section 2-2.
Refer to Section 2-3.
Refer to Section 2-4.
Refer to Section 2-5.
Refer to Section 2-6.
2-1 (E)
Advertisement
Table of Contents
