Table of Contents
Advertisement
PROBLEM
Motor will
Tank pressure exceeds
not run
preset pressure switch
limit
Make sure the Thermal
Overload Switch has not
tripped. The motor has
a built in thermal cut out
that trips when necessary
to protect the motor
from damage when
overheated.
Fuse blown or circuit
breaker tripped
Check valve stuck open
Wrong wire gauge in cord
or excessive extension
cord length
Loose electrical
connections
Paint spray on internal
motor parts
Possible defective motor Have checked at service center.
CAUSE
17 - ENG
CORRECTION
Motor will start automatically when
tank pressure drops below cut- in
pressure of pressure tank.
To reset the motor overload toggle turn
the pressure switch AUTO/OFF lever
to the OFF position and unplug the
unit from the power outlet. Allow 10
minutes (minimum) for motor overload
cut-out to cool and reset. Unit can
then be plugged in and re-started.
• Replace blown fuse or reset circuit
breaker. Do not use fuse or circuit
breaker with higher rating than
specified for your branch circuit.
• Check for proper fuse; "Fusetron"
type T is acceptable.
• Check for low voltage and
proper extension cord size.
• Disconnect other applications
from circuit. Operate compressor
on a dedicated circuit.
Remove and clean or replace.
Check for proper gauge and extension
cord length.
Contact authorized service center.
Have checked at service center. Do
not operate compressor in the paint
spray area
Advertisement
Table of Contents
