Auto-Dimming Mirror With Compass (If Equipped) - Subaru Legacy 2012 User Manual

begins to flash slowly (after approximately
20 seconds), position the hand-held trans-
mitter of the device between 1 to 3 inches
(25 to 76 mm) away from the HomeLink
button you wish to program.
3. Press and hold the hand-held trans-
mitter button. The HomeLink
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
The programming for the previous device
is now erased and the new device can be
operated by pressing the HomeLink
button.
! Erasing HomeLink
button memory
®
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
®
erased for security purposes.
®
indicator
®
1) HomeLink
®
2) HomeLink
3) HomeLink
1. Press and hold the two outer buttons
(button 1 and button 3) until the indicator
light begins to flash (after approximately
20 seconds).
2. Release both buttons.
! In case a problem occurs
If you cannot activate a device using the
buttons be
corresponding HomeLink
programming, contact HomeLink
www.homelink.com or call 1-800-355-
3515 for assistance.
button 1
®
button 2
®
button 3
®
button after
®
at
®
Instruments and controls
& Auto-dimming mirror with
compass (if equipped)
1) LED
2) Switch
3) Sensor
4) Compass display
The auto-dimming mirror has an anti-glare
feature which automatically reduces glare
coming from headlights of vehicles behind
you. It also contains a built-in compass.
. By pressing and holding the switch for
less than 3 seconds, the automatic dim-
ming function is toggled on or off. When
the automatic dimming function is on, the
LED indicator will illuminate.
Even with the mirror in anti-glare mode,
the mirror surface turns bright if the
transmission is shifted into reverse. This
– CONTINUED –
3-43