Subaru Legacy 2012 User Manual page 251

5-68
Audio
NOTE
While the phonebook is locked, if the
operation restricted menu is selected,
"PHBK LOCK" (type B audio)/"Phone-
book locked!" (type C audio) is dis-
played.
! Unlocking the phonebook
1. Select the "PHBK UNLOCK"/"PHONE-
BOOK UNLOCK" menu.
NOTE
If the phonebook is not locked, "UN-
LOCK" (type B audio)/"The phonebook
is unlocked." (type C audio) is dis-
played and the mode changes to the
security mode.
2. Input the PIN code by performing one
of the following procedures.
– Operate the "TUNE" dial.
– Press the talk switch
the number.
3. Select the "CONFIRM" (type B audio)/
"Confirm PIN?" (type C audio) menu.
– If the inputted PIN code is correct,
"UNLOCKED" (type B audio)/"The
phonebook is unlocked." (type C
audio) will be displayed and the
phonebook is unlocked.
! Phone setup
After selecting the "PHONE SETUP"
menu, perform the following procedure.
! Pairing phone
Refer to "Preparation for using the Hands-
free system" F5-53.
! Selecting phone
To select the registered cell phone for
connecting to the in-vehicle equipment,
perform the following procedure.
1. Select the "SELECT PHONE" menu.
– If no cell phones are registered,
"EMPTY" (type B audio)/"No Phones
have been paired." (type C audio) is
displayed and the mode changes to
the "PHONE SETUP" mode.
2. Select the cell phone by performing
one of the following procedures.
– Operate the "TUNE" dial.
and say
– Press the talk switch
the voice tag.
– Press the talk switch
the list phones function (refer to "List
phones function" F5-69.)
3. Select the "CONFIRM" (type B audio)/
"Confirm Phone selection?" (type C audio)
menu (only after saying the voice tag).
– "SELECTED" (type B audio)/
"Phone is selected." (type C audio) is
displayed, the selected cell phone is
connected to the in-vehicle equipment
and the mode changes to the "PHONE
SETUP" mode.
NOTE
For type B audio, if the cell phone
cannot be connected to the in-vehicle
equipment, "FAILED" is displayed and
the mode changes to the "PHONE
SETUP" mode.
! Changing the voice tag of the cell
phone
1. Select the "CHANGE NAME" (type B
audio)/"Change Phone Name" (type C
audio) menu.
– If no cell phones are registered,
"EMPTY" (type B audio)/"No Phones
have been paired." (type C audio) is
displayed and the mode changes to
the "PHONE SETUP" mode.
and say
2. Select the cell phone by performing
one of the following procedures.
and use
– Operate the "TUNE" dial.
– Press the talk switch
the voice tag.
– Press the talk switch
the list phones function (refer to "List
phones function" F5-69.).
3. Register the voice tag. For details,
and say
and use