Preparation For Use - Echo CS-670 Operator's Manual

Bolt (A)
Front hole (B)
Front hole (C)
Nut (F)
CS-670

PREPARATION FOR USE

Dimple (D)
®
Kick Guard
Recess (E)
Guide bar
Spiked bumper
Two bolts 5 × 12 mm
CAUTION
• All adjustment, should be made cold.
• Always wear gloves when working on chain.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in front hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16 in)
wrenches until snug. Make certain Kick Guard
is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
MOUNTING GUIDE BAR AND
CHAIN
• Install the spiked bumper on the front of
machine. (Use two bolts 5 × 12 mm)
8
®
TO BAR
®
P/N 28932 and
®
®
is tight on
®
must
®