Table of Contents
Advertisement
Hold the file tipped 10° upward
1/5
One fifth of file diameter remains
above cutter edge
Depth gauge tool
CS-670
25°
Keep this angle
Push file as shown
10°
Remove until
flat with tool
Round off
the edge
SETTING SAW CHAIN
• For setting saw chain, round file (5.6 mm dia.)
and flat file are used.
• To keep correct position and correct angle,
use the file holder (Sure Sharp).
- Round file (P-No. 897510-00230) and flat file
(P-No. 897511-00230) are optional.
- Inquire about the file holder, if desired.
• Place the depth gauge tool firmly on guide
bar so that depth gauge protrudes.
Then file top of depth gauge with flat the file until
flat with top of the depth gauge tool.
- Be sure to round off the front edge of the
depth gauge.
22
Hide quick links:
Advertisement
Table of Contents
