Yamaha Tyros3 Service Manual page 27

4
Insert the two DIMMs into the DIMM sockets.
Open the ejector levers, then insert the DIMM vertically
in the socket.
5
Re-install the cover you removed in step 3, in
reverse order.
168-pin DIMMs
Notch for alignment
Ejector levers
Insert the DIMM vertically in the
socket, aligning the notches to the
corresponding protrusions.
Make sure that the DIMM
module is aligned correctly
before you install it.
Press it in firmly until it
"snaps" or locks in place.
6
Check that the installed DIMMs are functioning
properly.
Set the Tyros3 right-side up, turn the power on and check
the WAVE RAM by accessing [VOICE CREATOR] →
[B] LIBRARY EDIT → [8 ▼ ] PROPERTY.
If the DIMMs have been installed properly, the
appropriate available memory size is indicated in the
display.
Removing DIMMs
Press the ejector levers
until the DIMM unlocks.
Tyros3
Pull the DIMM vertically
out of the socket.
27