Table of Contents
Advertisement
4. Lay the upper handle on the ground behind the lawn
mower with the handle label facing up.
Installing the Handle
WARNING
POTENTIAL HAZARD
Folding or unfolding the handle improperly can
pinch, stretch, or damage one or more of the
cables.
WHAT CAN HAPPEN
Any pinched, stretched, or damaged cable may
cause an operational failure that results in an
unsafe operating condition.
HOW TO AVOID THE HAZARD
Do not pinch, stretch, or damage the cables.
Handle the cables with care when folding or
unfolding the handle.
Do not use the lawn mower if one or more of
the cables are pinched, stretched, or damaged.
Contact your Authorized Service Dealer.
1. Loosen the handle height adjustment knobs and rotate
the lower handle toward the rear of the lawn mower
until it seats into one of the handle height settings as
shown in Figure 2 on page 8. To set the handle
height, refer to Adjusting the Handle Height on
page 8.
2. Remove the handle knobs and the oval head bolts from
the upper handle section.
3. Install the upper handle section onto the lower handle
section with the oval head bolts and the handle knobs
as shown in Figure 2. Tighten the handle knobs
securely.
1. Handle knob (2)
2. Oval head bolt (2)
3. Upper handle section
Installing the Starter Rope
Pull the starter rope through the rope guide on the handle
(Fig. 3).
1. Rope guide
Adjusting the Handle Height
You can set the handle to three height settings: high,
medium, and low (Fig. 2). Select the handle height setting
most comfortable for you.
1. Loosen the handle height adjustment knobs.
2. Set the handle to the desired position.
8
Figure 2
4. Lower handle section
5. Handle height adjustment
knob (2)
210
Figure 3
2. Starter rope
Advertisement
Table of Contents
