Installing The Battery; Assembling The Grass Bag - Toro Recycler 20826 Operator's Manual

3. Tighten the handle height adjustment knobs.

Installing the Battery

Electric Start Model only
1. Charge the battery. Refer to Charging the Battery on
page 24.
2. Align the pins in the battery case with the holes in the
lower handle, and lower the pins into the holes until
the battery case snaps into place (Fig. 4).
Figure 4
1. Battery case
2. Lower handle
3. Connect the wire lead from the battery to the wire lead
from the electrical wire harness in the corrugated tube
(Fig. 4).

Assembling the Grass Bag

1. Insert the grass bag frame into the grass bag as shown
in Figure 5.
3. Wire lead from battery
4. Wire lead from harness
1. Grass bag frame
2. Bag handle
3. Grass bag
Note: Make sure that the bag handle is on the outside of
the bag.
2. Position the bag cover on top of the frame as shown in
Figure 5.
3. Snap the top frame bar into the three snap fittings on
the bag cover as shown in Figure 6.
9
Figure 5
4. Bag cover
5. Bag base