Replacing The Fuse; Troubleshooting - Toro Recycler 20826 Operator's Manual

Replacing the Fuse

Electric Start Model only
A fuse protects the electrical system charging circuit. If
the battery does not stay charged, the fuse may be blown.
Use a 5-amp plug-in type fuse.
1. Remove and discard the blown fuse.
2. Install the new fuse as shown in Figure 33.

Troubleshooting

Toro designed and built your lawn mower for trouble-free operation. Check the following components and items carefully.
If a problem continues, see your Authorized Service Dealer.
PROBLEM
Engine will not start
Engine starts hard or loses power g
Engine runs rough g g
1. Fuse
CORRECTIVE ACTION
1. Fill the fuel tank with fresh gasoline.
2. Press the primer three times.
3. Connect the spark plug wire.
4. Clean the spark plug, check the spark plug gap, and replace
the spark plug if it is damaged.
1. Drain and fill the fuel tank with fresh gasoline.
2. Check the gasoline cap for ventilation; if the cap does not vent
air, replace it.
3. Clean the air filter.
4. Clean the lawn mower discharge chute.
5. Clean the underside of the lawn mower deck.
6. Clean the spark plug, check the spark plug gap, and replace
the spark plug if it is damaged.
7. Check the engine oil.
1. Connect the spark plug wire.
2. Clean the spark plug, check the spark plug gap, and replace
the spark plug if it is damaged.
3. Clean the air filter.
25
1
2
Figure 33
2. Fuse holder