Installing The Roll Over Protection System (Rops) - Toro TITAN ZX 74846 Setup Instructions

4
Installing the Roll Over
Protection System (ROPS)
Parts needed for this procedure:
1 Rollbar
2 Rollbar support
2
Reinforcing bracket
4 ROPS plates
10 Bolt (1/2 x 3–1/2 inches)
2 Bolt (1/2 x 4–1/2 inches)
8
Hex locknut (1/2 inch)
8 Flat washer (1/2 inch)
4 Thrust washer
10 Flange locknut (1/2 inch)
2 Bolt (5/16 x 3–3/4 inches)
2 Flange locknut (5/16 inch, may be pre-installed)
2 Flat washer (5/16 inch)
Installing the Rollbar Supports
Complete the following steps for both left and right rollbar
supports.
1. Locate the factory installed brace attached to the frame
between the engine and the rear wheel (see
and Figure 6).
Note: If preferred, the rear wheels may be removed
for easier access to the brace.
Location of the braces
Figure 5
Figure 5
13
14
15
1. Bolt (1/2 x 3–1/2 inches)
(2)
2. Thrush washer (4)
3. Rollbar support
4. Cutout faces the rear
5. Brace, existing
6. Bolt (1/2 x 1–1/4 inch) and
locknut (1/2 inch), existing
7. Seat belt assembly,
existing
8. Hex locknut (1/2 inch) (2)
2. Loosen the locknut that secures the brace to the frame.
Stop when the brace swings freely
3. Attach the rollbar support to the frame and the brace
to the rollbar support as shown in
the bolts loose enough that the parts are free to shift
around.
Note: Ensure that the cutout at the top of the support
tube faces the rear of the machine.
Note: Note the orientation of the reinforcing bracket.
4. Attach the rollbar support to the engine guard as
shown in Figure
Attaching the ROPS Plates
Assemble the ROPS plates to the rollbar as shown in
7. Leave the bolts loose enough that the parts are free to
shift around.
Note: Ensure that the locknuts are on the inside of the
support tube.
4
Figure 6
9. Flange locknut (1/2 inch)
(2)
10. Reinforcing bracket (2)
11. Bolt (1/2 x 4–1/2 inch) (2)
12. Bolt (5/16 x 3–3/4 inch) (2)
13. Flat washer (5/16 inch) (2)
14. Flange locknut (5/16 inch)
(2)
15. Engine guard
(Figure 6).
Figure 6. Leave
6.
g028588
Figure