Setup
1
Installing the Handle
Parts needed for this procedure:
1
Handle
2
Bolt (5/16 x 1-1/4 inches)
4
Washer
2
Thin locknut (5/16 inch)
2
Bolt (5/16 x 1-1/2 inches)
2
Locknut (5/16 inch)
1
Bag-support rod
2
Cap locknut
1
Cable tie
Procedure
1. Mount the handle to the outside of the machine
housing (using the bottom hole) with 2 bolts (5/16 x
1-1/4 inches), washers, and thin locknuts (5/16 inch)
(Figure 3).
1. Handle latch
2. Bag-support rod
3. Cap locknut (2)
2. Secure the handle latches to the handle with 2 bolts
(5/16 x 1-1/2 inches), washers, and locknuts (5/16
inch) (Figure 3).
Note: You can adjust the handle height for
comfortable operation. Stand behind the handle to
determine the height. To adjust the handle height,
position the bolts and the locknuts that secure the
handle latches to the handle into the other mounting
holes in the latches.
Figure 3
4. Handle
5. Bolt (5/16 x 1-1/2 inches)
6. Bolt (5/16 x 1-1/4 inches)
3. Slide the bag-support rod through the second from the
top mounting holes in the handle and secure each end
with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to the left
handle below the bag-support rod.
2
Installing the Starter Rope
No Parts Required
Procedure
Pull the recoil-starter rope through the rope guide on the
handle (Figure 4).
1. Recoil-starter rope
Note: To make the rope easier to install, squeeze the control
bar on the handle.
3
Installing the Fuel Tank
Parts needed for this procedure:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Slide the plastic clips on the front of the fuel tank onto
the fuel tank mount (Figure 5).
5
Figure 4
2. Rope guide