Removing The Machine From Storage - Toro Recycler 22197 Operator's Manual

5. Service the air filter; refer to
Servicing the Air Filter (page 15).
6. Lubricate the pivot arms; refer to
Lubricating the Pivot Arms (page 15).
7. Tighten all nuts, bolts, and screws.
8. Touch up all rusted or chipped paint surfaces with
paint available from an Authorized Service Dealer.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
3. Clean the spark plug or replace it if it is cracked,
broken, or if the electrodes are worn.
4. Install the spark plug and torque it to 17 ft-lb (23 N-m).
5. Perform any needed maintenance procedures; refer to
Maintenance (page 14).
6. Fill the fuel in the fuel tank with fresh gasoline.
7. Check the engine oil level.
8. Connect the wire to the spark plug.
22