Tuning Terrestrial Television Channels (Dvb-T); Tuning Television Channels From The Cable Provider (Dvb-C) - Grundig 48 VLE 5421 BG Instruction Manual

SETTiNgS
Tuning­terrestrial­television­channels­
(DvB-T)
1 In the »Source Setup« menu, in the »Connection Type«
line, select the option »Air« with »
2
Select the line »Scan Type« with »
< >
Use » « or » « to set the required scan type:
– » DTV«, scan for digital television channels;
– » ATV«, scan for analogue television c hannels;
– » ATV & DTV«, scan for analogue and d igital televi-
sion channels.
Caution:
The antenna power supply (5V
7
switched on if the antenna is an active i ndoor antenna
with a signal amplifier and it is not already supplied with
a voltage via a mains plug (or similar supply). Otherwise
you may cause a short circuit and irreparably damage
your antenna.
3
Select the line »Active Antenna Power« with »
» «.
Λ
Switch on the antenna power supply for the antenna with
< >
» « or » « (»On«).
4 Start the scan with »

– T he »Search Results« menu appears, and the search for
TV channels begins.
– D epending on the number of television channels re-
ceived, this can easily take a few minutes.
– T he scan is complete as soon as the »PROGRAM TABLE«
appears.
Note:
You can abort the scan by pressing »EXiT«.
7
5 Press »EXiT« to end the setting.
10­
ENGLISH
­-----------------------------------------------------------------------------------------------------------------------------------------
< >
« or » «.
« or » «.
v Λ
) may only be
« (green).
Tuning­television­channels­from­the­
cable­provider­(DvB-C)
1 In the »Source Setup« menu, in the »Connection Type«
line, select the option »Cable« with »
2
S elect the line »Scan Type« with »
<
Use » « or »
– » DTV«, scan for digital television channels;
– » ATV«, scan for analogue television c hannels;
– » ATV & DTV«, scan for analogue and d igital televi-
sion channels.
3 Select the line »Cabel Scan Type« with »
lect the preferred option (»Quick« or »Full«) with »
>
» «.
– T he search function »Quick« sets up the channels accord-
ing to the information provided by your cable provider in
the transmission signal.
– I f the option »Full« is selected, the entire frequency
range will be scanned. The search can take a long time
« or
v
with this option. This option is recommended if your
cable provider does not support the scan type »Quick«.
Note:
You can accelerate the search. To do this, you need in-
7
formation about the frequency and network ID. You are
usually able to get this data from your cable operator or
find it in forums on the Internet.
4
Start the scan with »
– T he »Search Results« menu appears, and the search for
TV channels begins.
– D epending on the number of television channels re-
ceived, this can easily take a few minutes.
– T he scan is complete as soon as the »PROGRAM TABLE«
appears.
Note:
You can abort the scan by pressing »EXiT«.
7
5 Press »EXiT« to end the setting.
<
« or »
« or »
v
>
« to set the required scan type:
« (green).

>
«.
«.
Λ
« or » «. Se-
v Λ
<
« or