Service, Optical Device(7G), Wire (Flat Type) - Sony MHC-V3 Service Manual

2-16. SERVICE, OPTICAL DEVICE(7G), WIRE (FLAT TYPE)

Note : Before disconnecting the wire (fl at type) (24 core) of optical pick-up block, solder the short-land.
1 six claws
8 four insulator screws
qs service,
optical device(7G)
qa insulator
6 belt
3 Insert the thin
wire (clip etc.).
4
Note: This illustration sees the loading assy (T) from bottom side.
1 wire (flat type) (24 core)
loading assy (T)
terminal face
2 Through the hole
2 chuck holder assy (T)
qa insulator
0
9
7 connector
qd base, lo assy
5 tray
5 two claws
3 Through the hole
Under the guide
(Fold area)
Under the guide
qf tape
qg wire (flat type)
(5 core)
qa insulator
qh
– Bottom view –
5 three claws
6 holder, FFC
4
7 wire (flat type)
(24 core)
9 wire (flat type)
(5 core)
MHC-V3/V4D
Ver. 1.1
qk tape
qj holder, FFC
ql wire (flat type)
(24 core)
loading assy (T)
0 tape
8 tape
23