MHC-V3/V4D
Ver. 1.1
2-5.
CDM BLOCK
2 four screws
(+BVTP 3
4 wire (flat type)
(24 core) (CN302)
5 wire (flat type)
(5 core) (CN303)
3 Remove the CDM block
in the direction of the arrow.
Note 1: When installing the wire (flat type), ensure that
the colored line is not slanted after insertion.
OK
Insert is straight to the interior.
wire (flat type)
colored line
connector
12
7 CDM block
8)
– Top rear view –
NG
Insert is incline
wire (flat type)
colored line
connector
2 two screws
(+BVTP 3
6 CN401
(6P)
hook
1 Remove the wire from the hook.
Note 2: When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
OK
Insert is straight
Insert is shallow
to the interior.
connector
connector
connector
8)
CDM block
DAMP board
NG
NG
Insert is incline
connector
connector
connector