Electrical Requirements - Vita-Mix 100 VAC Owner's Manual

High performance commercial blender 220/240 and 100 vac models

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

n-Counter Installation

Preparing the counter area:

• Before cutting holes, make sure that there is adequate clearance under

the counter for the motor. The motor will extend about 14.4 cm below the

counter but it is best to allow at least 25.4 cm from the under-counter to

shelves or any other equipment under the counter. Also, when using the

removable cover design, the back of the hole must be at least 15.2 cm

from any wall to allow for cover door clearance.

• An extra 16.5 cm of open space, above the top of the cover will be needed

for placement and removal of the In-Counter machine and for custom

programming the SIX PRE-SET Buttons.

• If installing unit into a closed cabinet, use a 10.1 cm diameter flexible vinyl

duct (dryer hose) to vent exhaust. Attach the vinyl duct to the bottom of

your In-Counter Touch and Go

the hose over the exhaust baffle of the unit. Run the vinyl duct out of the

cabinet for proper ventilation. Do not vent hose into a wall, ceiling, or a

concealed space of a building. Multiple units should not vent to a common

manifold unit but to separate places. If running your Blending Station

causes a suction on your cabinet door, place a spacer in the door frame

to allow proper intake of air.

Do not use hose clamps or equivalent to attach exhaust hose

on machine.

• When cutting holes for placement of multiple In-Counter units, position

the edge of the machines at least 30.48 cm apart to ensure quick cleaning

and proper venting between machines.

• In-Counter installation also requires you to have at least one outlet per

machine under the counter, available within six feet of the Blending

Station. Consult an electrician for proper electrical needs.

• The In-Counter Blending Station also requires a foam gasket (provided

in the machine's original package) to be placed between the machine

and the counter. See page 10 for instructions.

Blending Station

by forcing the end of