C Ustom Programming - Vita-Mix 100 VAC Owner's Manual

C ustom Programming
The Touch and Go TM Blending Station
custom programmed, requiring an optional programming chip, available
from Vita-Mix for a nominal fee and with a minimum unit purchase. Contact
your Vita-Mix representative for more information .
Programming your Touch and Go
Blending Station PRE-SET buttons
1. Insert the custom programmed chip with the
words, "THIS SIDE FACING TO THE FRONT
OF THE MACHINE" toward you, into the port
located below the label area on the front of the
Blending Station. The DISPLAY WINDOW will
read 'New Module'.
2. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and
the DISPLAY WINDOW will read 'Saved' then 'Ready'. If nothing happens
when the programming chip is fully inserted, turn the chip in the opposite
direction and try again.
3. Remove the programming chip and return it to the original package.
4. Press one of the six PRE-SET buttons to reveal, in the DISPLAY WINDOW,
the name of the program/drink.
NOTE: If for any reason the programmed times are incorrect, they can be
reset to the original factory settings following the instructions on page 7.
Programming your In Counter Touch and Go
Blending Station PRE-SET buttons
1. Remove the container from the machine.
2. Lift the machine from the bottom edges to reveal the motor and housing
area. With the machine facing towards you, locate the slot underneath on
the right hand side of the machine between the motor and the outer wall.
3. Insert the custom programmed chip into the slot with the words, "THIS
SIDE FACING TO THE FRONT OF THE MACHINE" turned facing out to
the right of the machine. Once inserted the DISPLAY WINDOW will read
'New Module'.
6
® advanced electronic control can be
Custom
Programmed
Chip
4. Within 10 seconds the SIX PRE-SET
buttons will be re-programmed and the
DISPLAY WINDOW will read 'Saved' then
'Ready'. If nothing happens when the
programming chip is fully inserted, turn the
chip in the opposite direction and try again.
3. Remove the programming chip and return
it to the original package.
5. Press one of the six PRE-SET buttons to
reveal, in the DISPLAY WINDOW, the
name of the program/drink.
6. Carefully place the Blending Station motor
back into the hole in the counter.
NOTE: If for any reason the programmed
times are incorrect, they can be reset to
the original factory settings following the
instructions below.
Resetting the PRE-SET buttons to the original
factory settings
WARNING: Reverting your PRE-SET PROGRAM buttons to the
original factory setting, will erase any programming installed with a
custom program chip.
1. Enter the OWNER CONTROLS (press the Vita-Mix Logo) and press the
PRE-SET buttons 1 and 6 when the DISPLAY WINDOW says 'Mode'.
2. Press the Vita-Mix Logo two more times to reveal the instructions on
resetting the PRE-SET buttons.
3. Press and hold the #4 button until the DISPLAY WINDOW reads
'Restoring Please Wait'. The PRE-SET buttons are now reset to the
original factory settings.
In-Counter
Custom
Hole
Programmed
Chip
7