Advertisement
HOW TO INSTALL AND REPLACE THE BATTERIES INTO THE THERMO-
HYGRO TRANSMITTER
The outdoor Thermo-hygro transmitter works with 2 x AA IEC LR6,
1.5V batteries. To install and replace the batteries, please follow the
steps below:
1.
2.
3.
4.
Note: When changing batteries in any of the units, all units need to be reset by following
the setup procedure. This is because the thermo-hygro sensor will assign a random
security code at start-up and this code must be received and stored by the weather centre
in the first several minutes of power being supplied to it.
HOW TO INSTALL AND REPLACE THE BATTERIES IN THE WEATHER
CENTRE
The Weather Centre works with 2 x C, IEC LR14, 1.5V batteries. When the batteries need
to be replaced, the low battery symbol will appear on the LCD.
Uninstall the rain cover of the transmitter.
Remove the battery compartment cover.
Insert the batteries, observing the correct polarity (see the
marking in the battery compartment).
Replace the battery cover and the rain cover onto the unit.
To install or replace the batteries, please follow
the steps below:
1.
2.
3.
4
Remove the battery compartment cover.
Insert the batteries observing the correct
polarity (see the marking in the battery
compartment).
Replace the battery cover.
Advertisement
