Mounting Other Brands - RIDGID AC9940 Owner's Manual

4. Slide flat washer on bolt and place
through miter saw and workstand.
5. Slide fender washer on the bolt and
"finger tighten" using lock nut.
6. Repeat steps 4 and 5 for the other
three mounting holes.
7. Tighten all lock nuts.

Mounting Other Brands

NOTE: Other brands of miter saws (not
RIDGID miter saws) will require additional
1/4" mounting holes to be drilled. See
instructions below.
1. Locate the following parts:
M6 x 40mm bolts ................................ 4
M6 Flat Washers................................. 4
M6 Fender Washers ........................... 4
M6 Lock Nuts...................................... 4
2. Center the miter saw on the workstand.
Check and make sure:
• The front of the miter saw faces the
front of the workstand as shown
above.
• The miter saw is mounted so the
workpiece is positioned in line with the
rollers as shown above.
• The mounting hardware will not inter-
fere with the sliding table frame mem-
bers underneath table. Shaded areas
on table show locations that mounting
hardware may interfere with folding/
locking mechanisms. Be sure to posi-
tion miter saw outside of these areas.
3. Mark the mounting hole(s) location.
Remove miter saw.
M6 Hex Head Bolt
M6 Flat Washer
Miter Saw
Workstand
M6 Fender
Washer
Hex Bolt
M6 x 40mm
Flat Washer
M6
Fender Washer
9
Workpiece in
line with roller
Roller
M6 Lock Nut
Lock Nut
M6
M6