Mounting And Aligning Roller Assemblies - RIDGID AC9940 Owner's Manual

Mounting Miter Saw (continued)
4. Drill 5/16" mounting holes.
5. Reposition the miter saw on the work-
stand.
6. Slide a flat washer on bolt and place
through miter saw and workstand.
7. Slide a fender washer on bolt and "fin-
ger tighten" using lock nut.
8. Repeat steps 6-7 for the other three
mounting holes.
9. Tighten all lock nuts.

Mounting and Aligning Roller Assemblies

1. Insert roller assembly into each exten-
sion bar.
NOTE: Make sure length stop is posi-
tioned towards miter saw.
NOTE: Load capacity of each roller is 100
pounds maximum.
2. Place a straight edge on the miter saw
table and adjust roller to table height.
Tighten knob to secure roller.
10
Do not drill holes
in shaded areas.
Length Stop