Folding And Moving Workstand; Before You Start; Folding Leg And Table - RIDGID AC9940 Owner's Manual

Folding and Moving Workstand

Before you start:

• Remove any workpieces.
• Make sure miter saw is securely
attached to the stand per the instructions
in this manual.
• Remove or secure any workpiece
clamps or other accessories.
• If a miter saw is already assembled to
the stand, make sure to place the blade
90° to the table (if applicable), miter the
blade to the right as far as it will go,
place the blade in the "locked down"
position, and lock all knobs and levers.

Folding Leg and Table

1. Loosen the roller foot knob and slide
foot extension up. Tighten knob.
2. Release locking pin and raise foot.
3. Unlock the extension bar lever and
slide extension bar in towards center.
Lock extension bar lever.
4. Repeat for other side.
5. At the wheel end of the stand firmly
grab the lift handle/lock lever and
squeeze the lever.
6. Fully lift table by the lift handle, then
slowly lower table down to the frame.
CAUTION: When lowering the
workstand, bend your knees so
you can use your legs, not your
back.
NOTE: You may need to adjust the speed
at which you bring up the table in order to
get the leg to fold.
7. Lift stand into upright position - pull out
on the spring pin knob and swing the
legs until they lock in place against the
bottom of the table.
8. Make sure the stand will remain upright
on its own.
CAUTION: If the stand will not
remain upright, store in the hori-
zontal position.
12
Lower the Table
Spring
Pin Knob
Push
the
Legs