Assembly; Attaching The Lower Foot - RIDGID AC9940 Owner's Manual

Assembly

Attaching the Lower Foot

1. Place stand assembly "flat" on floor.
2. Rotate lower foot into upright position
aligning holes as shown.
3. Locate the following parts:
M6 x 41mm bolt .................................. 2
M6 Flat Washer .................................. 4
M6 Locknut ......................................... 2
4. Install bolt, two washers and nut as
shown. Finger tighten nut.
5. Repeat step 4 on the opposite side.
6. Tighten all four nuts.
M6 x 41mm
Washer
M6
5
Hex Bolt
Lock Nut
M6