8. Insert and hand-tighten the four threaded rods into the threaded inserts located on the back of the control head.
9. Carefully slide the control head into the mounting hole and align the threaded rods with the drilled holes in the dashboard.
CAUTION! Do not force the control head into the mounting hole. If there is difficulty with the installation, check the drilled holes.
10. Place the hardware onto each threaded rod in the following order: L-bracket, flat washer, split ring lock washer, and nut (see the
illustration Mounting the Control Head).
11. Using a socket wrench, tighten each nut so that the split ring washer flattens. You can also apply thread locker (medium strength,
removable) to secure the installation.
CAUTION! The washers must be fully compressed for a secure installation.
control head rim
with rubber gasket
attached
Install the Control Head
Mounting the Control Head
threaded rod
underside view of the dashboard
3
L-bracket
split ring
lock washer
flat washer
nut