Set Up The Control Head - Humminbird ION 12 Installation Manual

Home Screen
Start Radar Transmission
If you have a radar connected to the control head system, use the
following instructions to start radar transmission.
WARNING! The radar must be configured before it can be used for
on-the-water operations. See the operations manual for
configuration instructions.
Start Radar Transmission
1. Confirm the radar power source is turned on (breaker or switch).
2. Press the HOME key
3. Tap the Radar view on the Favorites Bar, or use the Joystick to
select it and press the ENTER key
4. With the Radar view open on-screen, press the MENU key
5. Turn Transmit ON. A radar icon will appear in the system status
bar confirming the radar is transmitting (see Confirm Sensor
Connection).
Use the same instructions to turn Radar Transmit off.
S U
ET P THE
After completing the Setup Guide, use the following sections to configure basic system
settings and confirm operation.
PILOT
STANDBY
NOTE: See the Quick Start Guide and the control head operations manual that was
provided with your unit for additional information.
GO TO MARK
.
to open.
C H
ONTROL EAD
.
Transmit is ON.
10
Favorites Bar
Confirm Radar Transmission
Radar icon is displayed in the system status bar.
Radar data is displayed on-screen.

Set Up the Control Head