Table of Contents
Advertisement
My Vessel | Select NMEA 2000 Engines/Tanks and Vessel Dimensions
Use the following instructions to select the NMEA 2000 engines and/or tanks and the vessel dimensions of your boat.
Select Engines and Tanks with NMEA 2000 Sensors
If you have a NMEA 2000 network on your boat that is connected to the
engines and/or fuel tanks, select your current configuration to receive
NMEA 2000 data on your control head.
NOTE: See NMEA Input/Output for a complete list of compatible
NMEA sentences.
1. Select Engines/Tanks and open the submenu.
2. Select a setting and press the ENTER key
selection.
3. Tap the back arrow on-screen or press the EXIT key
to the main menu.
4. Select additional settings as needed.
Set Vessel Dimensions
It is important to set the height, width, and depth allowances required for
your vessel as that information affects the accuracy of auto route
calculations during navigation.
1. Select Vessel Dimensions and open the submenu.
2. Select a setting. Drag the slider, or use the Rotary Dial, to adjust the
setting.
3. Select additional settings as needed.
4. Tap the back arrow on-screen or press the EXIT key
to the main menu.
5. Select Confirm to confirm the selected settings.
The unit will automatically enter normal operation.
Setup Guide
to confirm the
to return
to return
9
Advertisement
Table of Contents
