Table of Contents
Advertisement
General Settings | Select Time and Date Format, and Units of Measurement
Select Units of Measurement
1. Select Units and open the submenu.
2. Select a menu option and open the submenu.
3. Select a setting and press the ENTER key
selection.
4. Tap the back arrow on-screen or press the EXIT key
to the submenu.
5. Repeat steps 2 through 4 to change another setting.
6. Tap the back arrow on-screen or press the EXIT key
to the main menu.
7. Select additional settings, as needed. Tap the right arrow
on-screen or press the RIGHT ARROW key
proceed to the next menu dialog box.
Chart | Select the Map Source and Water Level Offset
Humminbird is the built-in map source for your control head. You can also select Navionics or C-MAP by Jeppesen as your map source. If
you install an SD card with additional maps, set the map source to match the SD card type.
From this menu, you can also set the Water Level Offset (Humminbird charts only). Water Level Offset allows you to change the level of
the water being read from the control head. For example, if the lake is down 5 feet, set the Water Level Offset setting to -5. The displayed
numbers on the Contour Lines will adjust from the Water Level Offset setting. See your control head operations manual for more
information.
NOTE: If you trailer the boat to a new location, the Water Level Offset must be reset according to the current environment.
Select a Map Source
1. Select a map source and press the ENTER key
selection.
Set the Water Level Offset
1. Drag the slider, or use the Rotary Dial, to adjust the setting.
2. Tap the right arrow on-screen or press the RIGHT ARROW key
on the keypad to proceed to the next menu dialog box.
to confirm the
to return
to return
on the keypad to
to confirm the
8
current menu option setting
current menu option setting submenu
menu options
current menu option setting
submenu
back
current menu option setting
slider
Setup Guide
Advertisement
Table of Contents
