Panasonic KV-S1057C Service Manual page 195

F Start/Stop button
•
If you set [Wait Key] for "Manual Feed Mode" in your application software, pushing this button
starts scanning. For details about "Manual Feed Mode", refer to the Image Capture Plus,
TWAIN, or ISIS help.
•
During scanning, pushing this button stops scanning.
•
If you press this button after a double feed is detected and scanning has been paused, the
document (or documents) detected as a double feed will be ejected from the scanner without
being scanned. Scanning will stop.
n KV-S1057C and KV-S1027C only
G LCD
H OK button
If you are using the scanner with Image Capture Plus, you can perform a push scan using the LCD.
Registered jobs are displayed on the LCD. Use the cursor button (D) to select a job. Also, error
codes and messages corresponding to the scanner status are displayed on the LCD.
n KV-SL1066, KV-SL1056, KV-SL1055, KV-SL1036 and KV-SL1035 only
I 7-segment LED
If you are using the scanner with Image Capture Plus, you can perform a push scan using the
7-segment LED. A registered job number is displayed on the 7-segment LED. Use the cursor button
(D) to select a job.
Location of Controls
Operating Manual 15