Vision Fitness E3000 Assembly Manual page 6

PINK BAG
2
STEP
Tension Knob
Bracket
• Slide the console mast cover onto
the console mast.
Tension Knob
• With the included wire-tie, pull the
Console Mast
wire harness, or sensor wire through
the console mast. Insert the console
mast into the mast mounting-bracket.
Secure in place with seven screws
Console Mast
(M8x15L) and six lock washers (M8).
Cover
Tighten with the 5mm T-Shaped
wrench. NOTE: The screw facing the
seat does not use a lock washer.
Tighten this screw until snug with the
5mm L-Shaped wrench. Slide the con-
sole mast cover down over the screw
Mounting
Bracket
heads.
• MODEL E3000: Snap the tension
knob mounting bracket onto the ten-
sion knob. Turn the tension knob to
level 16. Connect the cable to the ten-
sion cable located inside the console
mast. Secure the tension knob to the
console mast with the washer (M5)
and screw (M5x70L). Tighten with
screwdriver.
2
STEP
• Slide the heart rate wires of the han-
E3000 ONLY
dlebar through the hole in the handle-
bar bracket on the console mast.
Secure the handlebar onto the
Console
handlebar bracket with two screws
(M8x20L) and two lock washers (M8).
Tighten with the 5mm T-Shaped
wrench.
• Remove the four mounting screws from
the back of the console. Connect the
wire harness and the heart rate wires to
the console. Attach the console to the
console mast using the four mounting
screws that were just removed.
• E3000 ONLY: Insert the two AA bat-
teries into the console.
• Attach the water bottle cage to the
Water Bottle
E3100 ONLY
console mast with two screws
Cage
(M5x15L) using the screwdriver. Insert
the water bottle into the cage.
6