Step - Vision Fitness R2600HRT Assembly Manual

1

STEP

Rear Foot
2
STEP
Console Mast
Console Mast
Boot
Frame
Bracket
5
ORANGE BAG
1
STEP
• Install the rear foot with the four
lock washers (M8), two inside
screws (M8x65L), and two outside
screws (M8x20L). Tighten with the
5mm Allen wrench.
BLUE BAG
2
STEP
• Slide the console mast boot onto the
console mast.
• Unfold the wire harness and heart
rate wires located in the console mast
frame bracket. Attach the wire tie
coming from the bottom of the console
mast to the wire harness and heart
rate wires. Pull the wire tie with wire
harness and heart rate wires up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the console mast to the
frame bracket with six lock washers
(M8) and six screws (M8x15L).
Tighten with the 5mm Allen wrench.
Place the seventh screw (M8x15L) in
the rear of the frame bracket and
tighten until snug.
• Slide the console mast boot down
and snap it into place on the side cover.