Cutting By Hand; Cutting Automatically - MUTOH ValueJet VJ-628MP Operation Manual

Cutting by hand

For media that cannot be cut with the built-in cutter in the product, please cut following the next steps.
[1]
Check printing is done.
[2]
[3] Open the front cover, and cut the media with a commercial available cutter.
• Cut along the media cut groove.
Media cut groove
CAUTION
Right after printing, Media guide becomes very hot.
Allow Media guide to cool down before the next operation.
[4]
Close the front cover.

Cutting automatically

In this product, a setup is possible to cut media automatically after printing is done. Refer to the setup methods described
below.
"Setting auto cut" on page 47
42

Cutting by hand

Feed the media to a position where printing results can be cut.
"Forwarding/Rewinding media" on page 40