CAUTION
Do not touch the electrodes with hands or damage them in any way as this could adversely
affect the measuring precision and repeatability.
Step 3. Tighten the screws to secure the contact board.
Step 4. Pull out the guide pin.
Step 5. Align the positioning tool with the guide hole in the contact board and insert the tool.
Step 6. The detached device holder block will leave the device holder lowered and locked with rod
protruding. Insert this device holder rod into the guide hole of the positioning tool, and
align with the position for mounting the device holder block.
Figure 3-6
Mount the Device Holder Bolck
Step 7. Tighten the screws of the device holder block.
Step 8. Remove the positioning tool.
Chapter 3
Selecting and Mounting the Contact Board
Operation
31