F Controller Specifications - HP Smart Array -UX 11i v2 Support Manual

Sas controllers for integrity servers
Hide thumbs Also See for Smart Array HP-UX 11i v2:
Table of Contents

Advertisement

F Controller specifications

This appendix provides specification details for HP Smart Array SAS Controllers.
Table 23 Smart Array P400 controller specifications
Dimensions (excluding bracket)
Power required
Time required to recharge battery
Duration of battery backup
Battery life expectancy
Operating temperature range
Storage/Shipping temperature range
Operating relative humidity (noncondensing)
RAID levels supported
Type of edge connector
PCI Express support
PCI Express transfer rate
Number of SAS ports
SAS transfer rate
Drive types supported
Cache size
Table 24 Smart Array P41 1 controller specifications
Dimensions (excluding bracket)
Disk drive and enclosure protocol support -
transfer rate
SAS connectors
Data transfer method
Memory bus speed
PCI
Simultaneous drive transfer ports
SAS port link rate
Software upgradeable firmware
Cache memory
Logical drives supported
Maximum capacity
1 18
Controller specifications
16.8 cm x 7.0 cm x 1.8 cm (6.61 in x 2.75 in x 0.7 in)
Approximately 14W
15 minutes to 2 hours, depending on initial battery charge level
More than two days if the battery is fully-charged and less than three
years old
More than three years
10º to 55º C (50º to 131º F)
-30º to 60º C (-22º to 140º F)
10% to 90% (Storage/Shipping 5% to 90%)
0, 1, 1+0, 5, 6 (ADG)
PCIe x8 (fits in slots that have a physical size of x8 or greater; operates
at the speed rating of the slot, up to a maximum of x8)
2.5 Gb/s PCI Express
2.0 GB/s peak bandwidth
Two internal wide ports; each port has four 1x connectors
1.2 GB/s per wide port peak bandwidth
3.0 Gb/s SAS
256 MB (approximately 48 MB is used by the onboard processor)
Low Profile PCIe Form Factor
19.05 cm x 24.13 cm x 5.72 cm (7.5 in x 9.5 in x 2.25 in)
6Gb/s SAS (Serial Attached SCSI)
3Gb/s SATA (Serial AT Attachment)
2 external (Mini SAS) x8 wide port connectors
x8 5G PCIe 2.0 Express (4 GB/s maximum bandwidth)
DDR2-800 MHz with 40 bit or 72-bit wide bus provides up to 4.2 GB/s
maximum bandwidth
PCIe Express Gen 2.0
2 x4 Wide SAS Ports
24 Gb/s per x4 wide port connector (4 x 6 Gb/s)
Yes
40-bit 256 MB Read/Write ECC protected cache; transportable with
battery backed upgrade
Up to 64 logical drives
100TB (100 x 1TB)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smart array hp-ux 11i v3

Table of Contents