LG LDG4315ST Service Manual page 61

30” freestanding gas double oven range
Hide thumbs Also See for LDG4315ST:
Table of Contents

Advertisement

Symptoms and Questions
Fan noise
Fan and burner operating in the oven
at normal bake
Burners are not lighting properly after
cleaning the cooktop surface.
When lighting just one burner,
clicking noise is heard from all the
burners.
My range is still dirty after running the
EasyClean® cycle. What else should
I do?
I tried scrubbing my oven after
running EasyClean®, but some soils
still remain. What can I do?
Soils on my oven walls are not
coming off. How can I get my walls
clean?
Will EasyClean® get all of the soils
and stains out completely?
Are there any tricks to getting some
of the stubborn soils out?
Is it safe for water to spill into the
oven bottom vents during cleaning?
TROUBLESHOOTING
• A convection fan may automatically turn on and off.
- This is normal.
It is normal for the fan to run while preheating during a regular bake cycle.
The fan motor may run periodically during a regular bake cycle. This is
to ensure even baking results.
The bake burner turns off if the door is left open during baking.
If the door is left open for longer than 30 seconds during baking, the
bake burner turns off. The bake burner turns back on automatically
once the door is closed.
Make sure that the burner heads and caps are completely dry and
properly positioned.
This is normal. Electric spark igniters from the burners cause the
clicking noise. All the spark igniters on the cooktop will activate when
igniting just one burner.
The EasyClean® cycle only helps to loosen light soils in your oven
range to assist in hand-cleaning of your oven. It does not automatically
remove all soils after the cycle. Some scrubbing of your oven range is
required after running the EasyClean® cycle.
EasyClean® feature works best when the soils are fully soaked and
submerged in water before running the cycle. If soils are not sufficiently
soaked in water, it can negatively affect cleaning performance. Repeat
the EasyClean® process using sufficient water. Sugar-based and
certain grease soils are especially hard to clean. If some stubborn soils
remain, use the Self Clean feature to thoroughly clean your oven.
Soils on the side and rear walls of your oven range may be more
difficult to fully soak with water. Repeat the EasyClean® process with
more than the 1/4 cup (2 oz) spray recommended.
It depends on the soil type. Sugar-based and certain grease stains are
especially hard to clean. Also, if stains are not sufficiently soaked in
water, then this can also negatively affect cleaning performance. If
stubborn or built-up stains remain, use the Self Clean feature. Refer to
the Self Clean section of your owner's manual.
Scraping the soils with a plastic scraper before and during
handcleaning cleaning is recommended. Fully saturating soils with
water is also recommended. However, certain types of soils are harder
to clean than others. For these stubborn soils, the
Self Clean cycle is recommended. Consult the Self Clean section of
your owner's manual for details.
Some water spillage into the oven bottom vents (gas range) is okay.
However, it is recommended to try avoid spilling too much water into
the vents.
8-5
Possible Cause/Solution

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ldg4313st

Table of Contents