LG LDG4315ST Service Manual page 48

WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
CAUTION
• Use caution when handling sheet
metal parts while servicing the
range.
- Some parts may have sharp edges, which
could result in injury.
3) UPPER OVEN BROIL BURNER
a) Remove oven door and Broil burner
assembly. Then remove the wire cover
using a phillips head screwdriver (See the
page 3-11).
b) Release the connector of the lgniter.
c) Remove the orifice spud from nozzle holder
using a 13/32" or 10mm wrench.
d) Install the LP orifce spud(F) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
CONVERSION TO LP GAS
6. Turn on the Electrical and Gas Supply to
continue with flame adjustment.
7. ADJUSTING THE AIR SHUTTER
To adjust the air shutter on the upper bake burner
for LP gas, loosen the Phillips head screw and
rotate the shutter fully open, as shown in Fig. 1.
NOTE: When converting the unit back to natural
gas the upper bake burner's air shutter should
also be fully open.
To adjust the air shutter on the broil burner for LP
gas, loosen the Phillips head screw and rotate
the shutter fully open.
NOTE: When converting the unit back to natural
gas the broil burner's air shutter should be fully
open.
Screw
Air Shutter
Check the flame size. The flame should have
approximately 1-inch blue cones.
After operating the burner for 30 seconds, check
for flame stability.
If the flame is lifting off of the burner ports,
gradually reduce the air
shutter opening until
flames have stabilized.
Some yellow tipping
may be normal when
used on LP.
5-4
Counterclockwise to
0.4inch(10mm) open position.
Fig.1
INNER CONE
OF FLAME
Approx. 1"
OVEN
BURNER