Electrolux Combi TOUCH Series User Manual page 60

Anom- Type of
Description
aly anomaly
dESC Stops Clean Boiler
boiler
EbOL Stops Boiler thermocouple
cycle/ failure
preheating
EbYP Warning Steam exhaust tem-
perature sensor failure.
ECEd Stops cycle Bottom cavity thermo-
couple failure
ECEu Stops cycle Bottom cavity thermo-
couple failure
EH2O Stops oven Water measured
inconsistent with
valves state
ELMb Stops Detected a problem
with the oxygen sensor
cooking
with steam
over 100
℃
EntC Stops oven component compart-
ment NTC failure
(NTC1)
Eotd Warning High temperature on
water drain
Eprb Stops oven Core probe failure
in Food
probe
mode
Ertc Warning Problem with internal
clock
ESCH Stops oven Component compart-
ment overtemperature
EStd Warning Water drain NTC
failure
60
Possible causes
Scale in the boiler
• Connector failure;
• TC sensor failure;
• PCB failure.
• Connector failure;
• TC sensor failure;
• PCB failure.
• Connector failure;
• TC sensor failure;
• PCB failure.
• Connector failure;
• TC sensor failure;
• PCB failure.
• Water supply valve
closed or partly closed;
• Temporary lack of water
supply pressure;
• Flow meter failure;
• Water system issue.
• Lambda probe failure.
• Connector failure;
• TC sensor failure;
• PCB failure.
Possible lack of water in the
drain system.
• Food probe misuse (for
example, wire pulled or
squeezed);
• Connector failure;
• Probe failure;
• PCB failure.
Issue with software or hard-
ware (for example battery
clock exhausted).
• Filter is dirty;
• Too high room
temperature
• Connector failure
• NTC sensor failure
• PCB failure
Actions
Run a cleaning program including the rinse and
descale cycle and use 2 tabs C25 only. (Follow
the procedure as per User Manual)
The oven can continue to work without preheat-
ing (check the cooking results).
• Inform Service about the failure.
The oven can continue to work, it is possible that
water consumption increases.
Call Service.
The oven can continue to work only with 100 ℃
cycle.
Call Service.
The oven can continue to work only with 100 ℃
cycle.
Call Service.
The oven can continue to work (check the cook-
ing results).
• Check if the water supply valve is open;
• Check the water pressure is > 1,5 bar;
• If the problem, persists call Service.
It is possible to continue using the oven in
Steam under 100 ℃
• Cooking results in Steam mode may be differ-
ent from usual.
• Call Service in case cooking results are
persistently unsatisfactory.
Electronic board temperature sensor damaged.
• Cooking impossible.
• Call Service.
• Check that the oven has water supply;
• Pour some water on the bottom cavity filter;
• If the problem persists call Service.
It is possible to run cycles based on time (without
food probe);
• If available, use the accessory USB food
probe;
• Call service to restore food probe mode
functionality.
It is possible that some functionality do not work
(for example HCCP).
• Call Service.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment;
• Clean the filter;
• Allow oven to cool before cooking;
• Call Service if the problem reoccurs.
The oven continue to work.
• Call Service to fix the issue