Samsung ProXpress C3010 Series Service Manual page 83

Code Display
109-0012 Inner Temp
109-0013 Outer Temp
109-0014 Humidity
109-0020 Fuser Fan Rdy
109-0034 Fuser Mot Rdy
109-0040 Fuser Fan Run
109-0140 Fuser Home
110-0000 LSU Mot1 Rdy
110-0060 LSU Mot1 Run
110-0080 LD Power1
110-0090 LD Power2
110-0100 LD Power3
110-0110 LD Power4
110-0140 LSU HSync1
110-0150 LSU HSync2
110-0160 LSU HSync3
110-0170 LSU HSync4
111-0080 ID Sensor
111-0090 IC Sensor Chk
6) Service Func. Menu
•
Service Func. > Clear All Mem.
The function resets the system to factory default settings. This function is used to reset the system to the initial value
when the product is functioning abnormally . All the values are returned to the default values, and all the information,
which was set by the user, will be erased.
NOTE
Always perform a memory clear after replacing the main board. Otherwise, the system may not operate properly.
•
Service Func. > Toner Low Level
The function is to set up the time to inform toner low status. This function can provide user convenience for replacing
the toner cartridge.
•
Service Func. > Engine Footer
This function is for monitoring of the engine status. If you perform this function, at printing, the setting value for engine
is shown on the bottom of the printed page.
•
Service Func. > F/W Upgrade
The function is to upgrade the firmware by using "usblist.exe" file. When updating firmware, you must select "On"
for this menu.
•
Service Func. > PartRep. Alert > Toner
This function is to set up whether or not to show the toner replacement alert.
Copyright© 1995-2017 SAMSUNG. All rights reserved.
Meaning
Inner Temperature
Outer Temperature
Humidity
Detects if Fuser Fan Motor runs at normal
speed.
Detect if Fuser Motor runs at each speed
Fuser Fan Motor On/Off
Detect if the fuser press is located Home
position.
Detects if LSU motor1 runs at normal speed.
LSU Motor1 On/Off
LSU LD1 Power On/Off (yellow)
LSU LD2 Power On/Off (magenta)
LSU LD3 Power On/Off (cyan)
LSU LD4 Power On/Off (black)
Detect LSU HSync1 (yellow)
Detect LSU HSync2 (magenta)
Detect LSU HSync3 (cyan)
Detect LSU HSync4 (black)
Start ID sensor sensing On/Off
Display ID sensor reading value
4. Alignment and Troubleshooting
State Displayed
Numeric 3 digits
Numeric 3 digits
Numeric 3 digits
High[Low]
High[Low]
On[Off]
High[Low]
High[Low]
On[Off]
On[Off]
On[Off]
On[Off]
On[Off]
High[Low]
High[Low]
High[Low]
High[Low]
On[Off]
Numeric 3 digits
4-22