Table of Contents
Advertisement
ATTACHING THE OVERLAY PANEL TO THE DOOR
1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove
the door by angling the door off of the bottom hinge pin.
2. Peel back the door gasket to expose the screw holes.
3. Set the overlay panel flush to the front of the door in the desired location. Clamp the overlay panel to the door if
necessary.
4. Insert the wood screws through the back of the door into the pilot holes in the overlay panel and tighten.
5. Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.
6. Install the door to the unit. Use the supplied plastic washer as shown in the figure below.
7. Realigning the door may be necessary. Any final door adjustments can be made using a 1/8" allen head driver to
adjust the door's brackets. (See figure below)
8. Attach the door light striker plate as shown using the 5/16" hex or phillips head screws provided. Make certain the
light is able to turn on and off when the door is opened and closed.
9. Attach the door to the unit by reversing step number 1 above.
H H i i n n g g e e H H a a r r d d w w a a r r e e I I n n s s t t a a l l l l a a t t i i o o n n
D D e e t t a a i i l l s s
CAUTION
Door can become
disengaged if washers
are not installed.
CAUTION
Door may not swing properly
if all nylon components are
not installed as shown
Bottom Hinge Cover
CAUTION
Door can become
disengaged if
washers are not
installed.
Overlay
Panel
Door Hinge
Shoulder bushing
3/4" OD x 7/16"
ID Washer
3/4" OD x 1/4" ID
Washer
(3) Nylon hardware
components at
bottom hinge
Top Hinge Cover
(2) Nylon
hardware
Cabinet
components at
Hinge
top hinge
5/8"x 7/32" ID washer
Shoulder
bushing
Door Hinge
Overlay
Panel
adjustment screws
Attached overlay
panel
9
Magnetic door
gasket
Rear of Door
1/8" allen head screws for hinge
adjustment
Door hinge
3/8" clearance
holes for
frame wood
screws -
10 holes
Door light striker plate
Bottom of door
Advertisement
Table of Contents
