Table of Contents
Advertisement
TROUBLESHOOTING CHART
P P r r o o b b l l e e m m
Odor in cabinet
Unit operates but does not
produce any ice
Small ice cubes
Noisy operation
Ice cubes sticking together.
P P o o s s s s i i b b l l e e C C a a u u s s e e
Interior needs cleaning.
The unit has just been started and it
has been less than 24 hours.
Water supply is not turned on.
Inadequate water pressure to unit.
The ice maker bale arm is in the
uppermost position
Freezer section has not reached
temperature.
Thermostat control knob is too warm.
Blower inlet and/or outlet is restricted. Keep blower area clear from commodities for
Condenser fan air flow is restricted.
Room and/or water temperature is too Move the unit to an area where ambient
warm.
Water input may require adjustment
Cabinet not level;
weak floor structure.
Water line tubing vibration
Ice consumption is low.
Room temperature is too warm.
S S o o l l u u t t i i o o n n
Clean the interior using a solution of baking
soda and war water or water and mild soap
Typical ice production is 2 lbs per day. Allow
for the freezer section to reach temperature
and the ice maker to cycle and accumulate
ice.
Turn on water supply to the unit.
Water pressure must be at a minimum 20 psi.
When the ice maker arm is in the uppermost
position, the ice maker is off. Flip the bale
arm down to turn on the ice maker.
Allow the freezer section to reach
temperature.
Turn the temperature control knob to a
higher number to allow the unit to run
colder. Allow 24 hours before readjusting
the temperature control.
proper operation.
Make certain the grille in front of the unit is
free and open for proper air circulation.
Check and clean the condenser coil by
removing the grille in the front of the unit.
Clean the condenser with a vacuum and
brush attachment.
temperature is below 90
not be placed next to a heat source such as
an oven. Check for cold water connection.
Due to differing water pressures, the ice
maker water input may require adjusting.
Adjust the leveling legs on the unit.
The unit must be locate on a sound and
sturdy floor for proper operation.
Adjust the tubing as necessary to prevent
unwanted vibrations.
Use the ice in the bin frequently. Ice will
stick together if left in insulated bin over
long periods of time.
Move the unit to an area where temperature
is below 90
15
F. The unit should
o
F.
o
Advertisement
Table of Contents
