Drain Plumbing; Gravity Drain; Drain Pump - Viking 15" W Use & Installation Instructions Manual

DRAIN PLUMBING

Your ice machine uses a gravity drain that requires 5/8" (.63 cm) ID tubing from the back of the
ice maker to a plumbed connection to a sanitary sewer (see Gravity Drain drawing below).
Remove the access panel, with a 5/16" (0.8 cm) wrench to plumb in drain connection. Gravity
drain location for built-in units can be within the area shown in illustration below. An optional
drain pump can be purchased for your ice machine if a gravity drain is not accessible.
Observe and follow all local codes when installing an ice machine.

GRAVITY DRAIN

DRAIN FROM
ICE MAKER

DRAIN PUMP

Model Number - VUIM-DP
( ( S S o o l l d d s s e e p p a a r r a a t t e e l l y y - - s s e e e e i i n n s s t t a a l l l l a a t t i i o o n n
i i n n s s t t r r u u c c t t i i o o n n s s s s u u p p p p l l i i e e d d w w i i t t h h d d r r a a i i n n
p p u u m m p p ) )
5/8" (.63 cm) I.D.
DRAIN TUBING
AND HOSE CLAMP
DRAIN TRAP
ICE MAKER
POWER CORD
DRAIN PUMP
POWER CORD
VENT TUBE GOES THRU THIS OPENING
VENT TUBE GOES THRU THIS
OPENING}{ IN THE ACCESS PANEL
24 5/8" (62.6 cm)
22" (55.9 cm)
T T o o p p o o f f
F F r r o o n n t t o o f f
U U n n i i t t
U U n n i i t t
1 1/2" (3.8 cm) DRAIN
PIPE
ACCESS PANEL
TUBING CLAMPS
SUPPLIED SCREWS
DRAIN FROM
ICE MAKER
DRAIN PUMP
IN THE ACCESS PANEL
11
WARNING
F F a a i i l l u u r r e e t t o o u u s s e e a a d d e e q q u u a a t t e e
d d r r a a i i n n a a g g e e s s y y s s t t e e m m w w i i l l l l r r e e s s u u l l t t
i i n n s s u u r r r r o o u u n n d d i i n n g g w w a a t t e e r r
d d a a m m a a g g e e a a n n d d / / o o r r p p o o o o r r i i c c e e
p p r r o o d d u u c c t t i i o o n n . .
GRAVITY DRAIN LOCATION
6 3/4"
(17.1 cm)
2 3/8" (6.0 cm)
4 1/16"
(10.3 cm)
VENT TUBE
DISCHARGE TUBE GOES THRU
THIS OPENING IN THE ACCESS PANEL
ACCESS PANEL
DRAIN PUMP'S DISCHARGE
DRAIN PUMP'S}{ DISCHARGE
LINE THRU THIS OPENING
LINE THRU}{ THIS OPENING
14 3/4"
(37.5 cm)