Central Machinery 67690 Set Up And Operating Instructions Manual page 10

2. Once Drive Center is removed,
thread Faceplate onto Main Spindle
and hand-tighten only. See Figure 2.
Figure 2
3. To attach Sanding Disc (34), align
flat Set Screw (55) at the back of
Sanding Disc with the flat face of
Spindle and then slide Disc over
Spindle. Then use Hex Wrench (71)
to tighten Set Screw. See Figure 3,
below.
Hex
Wrench
(71)
Set
Sanding
Screw
Disc
(55)
(34)
Figure 3
SKU 67690 For technical questions, please call 1-800-444-3353.
Spindle (2)
Faceplate
(9)
4. To install Work Table (36), slide Table
Bracket (39) into slot on the belt
housing. Then use Set Screw and
Hex Wrench to fasten the Bracket.
See Figure 4.
Set Screw
Hex
(55)
Wrench
(71)
Lock
Screw
(38)
Figure 4
5. Use the Lock Screw (38) to secure
Table Angle Gauge (37) to the Work
Table. See Figure 4.
6. Once the Work Table is secured, set
the Miter Gauge (43) onto the Work
Table by sliding the Miter Gauge
Slider (46) into the groove on the
Work Table. See Figure 5, below.
Work
Table
(36)
Miter
Gauge
(43)
Figure 5
Table
Bracket
(39)
Work
Table
(36)
Miter
Gauge
Slider
(46)
Page 10